Posted by admin on
Session 8: Properties and Manufacturing Checks Quiz 17.4
Time limit: 0
Quiz Summary
0 of 6 Questions completed
Questions:
Information
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
Results
Quiz complete. Results are being recorded.
Results
0 of 6 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 6
1. Question
Which two properties are added to J1?
CorrectIncorrect -
Question 2 of 6
2. Question
Which two nets are given the Min_Line_Width of 0.4mm?
CorrectIncorrect -
Question 3 of 6
3. Question
Which command is used to Show the properties?
CorrectIncorrect -
Question 4 of 6
4. Question
Which of these is NOT a Design for Fabrication Check?
CorrectIncorrect -
Question 5 of 6
5. Question
What is the other method to restrict Components being too close to the Design_Outline?
CorrectIncorrect -
Question 6 of 6
6. Question
Where are the Design for Manufacturing Rules enabled?
CorrectIncorrect